Introducing the long awaited Baja Skunkworks ROTO START. This ROTO START removes the pain and anguish it takes to start your R/C car or scooter. The enclosed case has been machined from 6061 Billet aluminum to prevent damage from outside elements. All hardware included. Some assembly required.

Set of two (2) Pro-Line Bow-Tie tires mounted on Desperado tires.
 
Excavator Tire preassembled on Desperado Wheel • Tall, aggressive tread annihilates the ground below • Ridiculous tread life due to oversized tread pattern • For use to convert your 5B into a Truck or can be used with you 5T (Not a stock replacement for 5T. Additional trimming may be necessary with stock 5T body) • Molded from durable, long-lasting yet soft XTR compound • Complete with new and improved blue molded foam insert •  • Aggressive 6 spoke design immediately enhances the look of your ride • Available preassembled in black/black • Extra Heavy-duty bead-locks front and rear for complete capture of tire and will take any punishment you throw at them • Molded from extremely strong nylon material

The new TGN Track Pipe is here for the HPI Baja 5B and 5T and available now from us or your favorite TGN dealer. Includes mounting brackets for the 5B and 5T with stingers located on bottom of the pipe to accommodate the 5T Truck

The new race pipe was NOT designed for the light hearted. It is a ballz out ridiculously powerful pipe. This pipe has and absolutely amazingly smooth power band.

Turtle Racing has completely redesigned the clutch system for your HPI Baja. The TR HD Clutch System is sold as a complete System and includes, Enclosed or open Clutch Bell Carrier, HD Clutch Bell, Original One Piece Gear Plate, Robinson Racing Pinion Gear, Fast Eddy Bearings and all Hardware necessary for installation.

6061 Billet Aluminum Clutch Bell Carrier with HUGE Fast Eddy Bearings, Largest Clutch Bell bearings offered by any Manufacturer. The Large Fast Eddy bearing provides longer bearing life and a very solid support for the clutch bell. The new TR Enclosed Carrier is vented properly so it is difficult for dirt and sand to enter, but it allows heat and expansion to disperse. The TR HD-Clutch Bells are machined from Billet Steel, to ensure concentricity and the strongest bell possible. No welds to break. Turtle has drilled and tapped the TR HD-Clutch bell for a M6 Pinion Screw!! Compare that to the stock M4, you WILL NOT break pinion screws anymore! If you break a pinion screw during driving, turtle will replace the screw, bell and pinion