Walbro WT-813 high-performance carburetor with modified throttle shaft (part av513) preinstalled for maximum compatibility. This is the carburetor recommended by Zenoah for upgrading your RC-style engine. This carb does not have an internal choke. Engines with the standard carburetor (WT-603, WT-668, etc) tend to experience a lag in low-end acceleration when tuned for peak power. The new carburetor includes an internal acceleration pump to allow faster recovery as throttle increases. Carburetor specs: Walbro WT-813. 15.88mm bore, 12.7mm venturi, independent tunable high and low speed jets. Fits Zenoah G23LH / G2D / G230RC / G260RC / G231PUH / G260PUH / G260PU / G231PUM / G260PUM engines. Also fits Chung Yang CY23RC / CY26RC / CY27RC / CY29RC / GP290 engines. Compatible with HPI Baja 5b.

New! Billet cylinder reed induction system from Proline Racing. Available exclusively at DDM. Updated "Shorty" style places the reed block closer to the cylinder, for even better performance! Includes custom engraved billet reed block with case pulse tap, carbon fiber reed petals, and all mounting hardware and gaskets. Installation requires tapping a 10/32 hole into the bottom of the carburetor or crankcase for the pulse line. Significantly improves power throughout the RPM range. Requires intake porting for proper performance - instructions are included. Fits Zenoah G23LH / G230RC / G260RC / G231PUM / G260PUM / G260PU / G260PUH engines. Also fits Chung Yang CY23RC / CY26RC / CY27RC / CY29RC / GP290 engines. Works with Walbro WA / WT series carburetors

Ever had your throttle linkage get stuck, leaving your throttle all the way open? Here is the best solution. The Yamadude throttle linkage!

 

If you run in a lot of dirt and sand the stock slider at the carb just gets hammered with sand. Even with side window,s it gets in there and makes that slide hang up causing brake drag and throttle sticking issues. You can try and drill out the slider but mud and sand still gets built up in there.


This set up moves the linkage farther up to the front and tucks nicely under the body.

Another thing it does is it gets rid of that stupid clip thing thats a pain to get on and off and loosens up over time and fails to stay on after a few removals. Another plus is you can set your brakes and throttle at the collars instead of trying to get you fingers in there and adjust that little brake adjuster.

The way these are set up you will have to clip the corner of your choke lever(if your running a stock style) to clear the end of the linkage.

 

Includes all parts shown, and detailed installation instructions.

Full-Force RC high flow fuel line kit for HPI Baja 5b. This is an absolute must have item if you want to get more power out of any engine on the 5B. This high flow fuel line kit comes complete with 2 feet of Tygon large fuel line, pre formed 5/32" brass tubing with fuel line barbs at all connections, and five fuel line clips. Check your stock fuel lines as they enter the tank and see how restricted they are as they pass through the grommet. This kit will increase your flow, prevent restriction and increase the horsepower of any engine!

BLUR - Spritfilter. The Spritfilter has a "unique" cleaning function. Internal filter on the inside and perfectly sealed! Ideal for all RC Cars and Scooters with CY or Zenoah engines! The Spritfilter combo weighs only 8g. Spritfilter is red anodized and with an engraving "BLUR"

Fits most fuel lines, tubes or cables around ¼”.

Use this sleeve to cover any fuel line or cables on your RC truck or Car. Includes 4 feet of sleeve, 4 cable ties and instructions.